Cables > MORE CABLES...

V.35 is the ITU (formerly CCITT) standard termed “Data Transmission at 48 kbps Using 60–108 KHz Group-Band Circuits.“

Basically, V.35 is a high-speed serial interface designed to support both higher data rates and connectivity between DTEs (data-terminal equipment) or DCEs (data-communication equipment) over digital lines.

Recognizable by its blocky, 34-pin connector, V.35 combines the bandwidth of several telephone circuits to provide the high-speed interface between a DTE or DCE and a CSU/DSU (Channel Service Unit/Data Service Unit).

Although it’s commonly used to support speeds ranging anywhere from 48 to 64 kbps, much higher rates are possible. For instance, maximum V.35 cable distances can theoretically range up to 4000 feet (1200 m) at speeds up to 100 kbps. Actual distances will depend on your equipment and cable.

To achieve such high speeds and great distances, V.35 combines both balanced and unbalanced voltage signals on the same interface.

RS-232, also known as RS-232C and TIA/EIA-232-E, is a group of electrical, functional, and mechanical specifications for interfaces between computers, terminals, and modems. The RS-232 standard was developed by the Electrical Industries Association (EIA), and it defines requirements for connecting data communications equipment (DCE)—modems, converters, etc.—and data terminal equipment (DTE)—computers, controllers, etc.) devices.

The standard, which is functionally equivalent to ITU V.24/V.28, specifies the workings of the interface, circuitry, and connector pinning. Both sync and async binary data transmission fall under RS-232. Most PCs use the RS-232 interface to transmit data to modems, and some printers even use it.

Although RS-232 is a “standard,” you cannot necessarily expect seamless communication between two RS-232 devices. Why? Because different devices have different circuitry or pinning, and different wires may be designated to perform different functions.

The typical RS-232 connector is DB25, but some PCs and other data communication devices have DB9 connectors. To connect 9-pin PC ports to devices with 25-pin connectors, you need a simple adapter cable. The most commonly used interface, RS-232 is ideal for transmitting data at speeds up to 20 kbps and over distances up to 50 feet (15.2 m).

Solid-conductor cable is designed for backbone and horizontal cable runs. Use it for runs between two wiring closets or from the wiring closet to a wallplate. Solid cable shouldn’t be bent, flexed, or twisted repeatedly. Its attenuation is lower than that of stranded-conductor cable.

Stranded cable is for use in shorter runs between network interface cards (NICs) and wallplates or between concentrators and patch panels, hubs, and other rackmounted equipment. Stranded-conductor cable is much more flexible than solid-core cable. However, attenuation is higher in stranded-conductor cable, so the total length of stranded cable in your system should be kept to a minimum to reduce signal degradation.