Cables > MORE CABLES...

The Ethernet standard supports 10-, 100-, and 1000-Mbps speeds. It supports both half- and full-duplex configurations over twisted-pair and fiber cable, as well as half-duplex over coax cable.

However, the Thick and ThinNet Ethernet standards support only 10-Mbps speeds.

Standard (Thick) Ethernet (10BASE5)
• Uses “Thick” coax cable with N-type connectors for a backbone and a transceiver cable with 15-pin connectors from the transceiver to the network interface card.
• The maximum number of segments is five, but only three can have computers attached. The others are for network extension.
• The maximum length of one segment is 500 meters.
• The maximum total length of all segments is 2500 meters.
• The maximum length of one transceiver cable is 50 meters.
• The minimum distance between transceivers is 2.5 meters.
• No more than 100 transceiver connections per segment are allowed. A repeater counts as a station for both segments.

Thin Ethernet (ThinNet) (10BASE2)
• Uses “Thin” coax cable (RG-58A/U or RG-58C/U).
• The maximum length of one segment is 185 meters.
• The maximum number of segments is five.
• The maximum total length of all segments is 925 meters.
• The minimum distance between T-connectors is 0.5 meters.
• No more than 30 connections per segment are allowed.
• T-connectors must be plugged directly into each device.

Smart Serial is the Cisco router interface. It uses a space-saving 26-pin connector that automatically detects RS-232, RS-449, RS-530, X.21, and V.35 interfaces for both DTE and DCE devices based on the type of cable used.

Smart Serial connectors can be found on Smart Serial cables and on the dual-serial-port WAN interface cards used in Cisco 2600 and 1720 series routers. The cables feature a Smart Serial connector on one end and a standard cable connector (such as DB25 or V.35) on the other end. The Smart Serial connector attaches to the dual-serial-port WAN interface card.

Each port on the WAN interface card features a Smart Serial connector. Ports can be configured independently to support two different physical interfaces. For example, you can run RS-232 cable to one port and RS-449 cable to the other port using a single WAN interface card.

What if you need to replace that RS-232 cable with V.35 cable? Just plug a Smart Serial–V.35 cable into the port. Because any Smart Serial connector on the WAN interface card attaches to any Smart Serial cable connector, no additional interface or adapter is necessary. Changing the configuration of your network is literally a snap!