Product Data Sheets (pdf)...Ultra2 LVD SCSI Cables and Terminators
Black Box Explains... SCSI termination
Product Data Sheets (pdf)...SCSI Adapters
This is the oldest method of termination. A passive terminator sits on the bus to minimize reflections at the end of the cable. Passive terminators simply provide impedance close... more/see it nowto that of the cable. The terminator is “passive” because it doesnt do any work to regulate power for termination; it relies on the interface card to provide steady power.
This is a more stable form of terminating SCSI cables. Active terminators control the impedance at the end of the SCSI bus by using a voltage regulator, not just the power supplied by the interface card.
Of all SCSI terminators, this is the most complex. A cable with a forced-perfect terminator can actually change its impedance to compensate for variations along the bus. Forced-perfect terminators force the impedance of the cable to match each device through diode switching and biasing. collapse
Black Box Explains...SCSI-1, SCSI-2, SCSI-3, and SCSI-5.
There are standards
and there are standards applied in real-world applications. This Black Box Explains illustrates how SCSI is interpreted by many SCSI manufacturers. Think of these as common SCSI connector... more/see it nowtypes, not as firm SCSI specifications. Notice, for instance, theres a SCSI-5, which isnt listed among the other approved and proposed specifications. However, for advanced SCSI multiport applications, SCSI-5 is often the connector of choice.
Supports transfer rates up to 5 MBps and seven SCSI devices on an 8-bit bus. The most common connector is the Centronics® 50 or a DB50. A Micro Ribbon 50 is also used for internal connections. SCSI-1 equipment, such as controllers, can also have Burndy 60 or 68 connectors.
SCSI-2 introduced optional 16- and 32-bit buses called Wide SCSI. Transfer rate is normally 10 MBps but SCSI-2 can go up to 40 MBps with Wide and Fast SCSI. SCSI-2 usually features a Micro D 50-pin connector with thumbclips. Its also known as Mini 50 or Micro DB50. A Micro Ribbon 60 connector may also be used for internal connections.
Found in many high-end systems, SCSI-3 commonly uses a Micro D 68-pin connector with thumbscrews. Its also known as Mini 68. The most common bus width is 16 bits with transfer rates of 20 MBps.
SCSI-5 is also called a Very High-Density Connector Interface (VHDCI) or 0.8-mm connector. Its similar to the SCSI-3 MD68 connector in that it has 68 pins, but it has a much smaller footprint. SCSI-5 is designed for SCSI-5, next-generation SCSI connections. Manufacturers are integrating this 0.8-mm design into controller cards. Its also the connector of choice for advanced SCSI multiport applications. Up to four channels can be accommodated in one card slot. Connections are easier where space is limited. collapse